DALI-2 addressable module, 2 channels

Support of DALI device types (control gear):

• DT0 (Fluorescent, lamp control gear)
• DT1 (Self-contained emergency, control gear)
• DT2 (Discharge HID, lamp control gear)
• DT3 (Low-voltage halogen, lamp control gear)
• DT4 (Incandescent lamp, dimmer)
• DT5 (Conversion to D.C. voltage, 1 – 10V, 0 – 10V converter)
• DT6 (LED lamp, control gear)
• DT7 (Switching, relay control gear)

DALI device type DT8 (Colour, Control gear) is not yet supported. Colour control is possible in DT6 mode if the DALI-2 addressable module is connected to a third-party DALI-2 LED driver that can be configured in a dual DT6 operating mode. In this set-up, two DALI-2 addresses are used: one to control light intensity and another to set the colour temperature. See guide.niko.eu for more details.

• Sliding contact to connect the module to the following module on the DIN rail
• Input voltage: 230 Vac ± 10 %, 50 Hz
• Maximum MCB rating: 16 A (limited by national installation rules)
• Output voltage: DALI
• Wire capacity
  • 3 x 1.5 mm² of 2 x 2.5 mm² or 1 x 4 mm² wire per terminal
• Maximum standby consumption: 1,9 W
• DIN dimensions: 4U
• Dimensions (HxWxD): 90 x 70 x 66 mm
• Marking: CE