Motor module

• Function: The motor module can operate three applications that are motor-controlled, such as roll-down shutters, curtains or sunblinds.

Each module can operate up to three motors. The desired opening and closing times can be entered via the programming software. This will ensure that the exact position of the roll-down shutter is known at all times, and it allows you to enter the position of your preference. Buttons “D”can be used to manually activate or deactivate the motors from the motor module via low-energy bistable relays in the module. The status of the relay only changes when a data pulse is generated by the controller or by one of the switch buttons. Please remember that the manual activation or deactivation is only temporary as it will be overruled by the next bus communication.

When the module is functioning properly, the STATUS LED will light up in TEST mode only. If one or several errors occur, the LED will blink to indicate the error code of the error with the highest priority.

• only 1 phase per motor module should be connected
• switching delay: 0.5 s
• maximum number of motors permitted: 3
• maximum 6A per output
• Sliding contact to connect the module to the following module on the DIN rail
• Input voltage: 230 Vac ± 10 %, 50 Hz
• Maximum MCB rating: 16 A (limited by national installation rules)
• Connection terminals: 2 x 8 screw terminals
• Wire capacity
  • 3 x 1.5 mm² of 2 x 2.5 mm² or 1 x 4 mm² wire per terminal
• DIN dimensions: 4U
• Dimensions (HxWxD): 90 x 70 x 66 mm
• Marking: CE